PI4CC

Contest Club
QRV since 1993.

PI4CC

The Wifi controller.

We designed a universal controller around a arduino clone with wifi. At the other end is the PI with Node-RED server connected to the LAN. To control the RX-array you need the 4 relay version.

A list of components we used:

Connect the all the COM on the web relay board to + 12V on the switch PCB.
Connect the relay 1 NO on the web relay server to relay 1 on the switch PCB.
Do the same for relay 2, 3 ,4 NO to 2 ,3, 4 on the switch PCB.

Wire up the arduino and upload the sketch to the arduino. In the sketch is some explanation how to setup the board and info on the routines. You need to add your wifi access details.
For some it hard to understand how its works. I don't give any support how to configure the arduino. There is a lot of info on the WWW

photo

The arduino clone with wifi onboard.

photo

The externa; wifi antenna the extrend the range. The build in antnna on the PCB is so so

photo

A look in site.

photo

The controller ready to use.

© Copyright 1996 - 2026 PI4CC All rights reserved.