PI4CC

Contest Club
QRV since 1993.

PI4CC

VE6WZ

Steve, VE6WZ made his version of the RX-amp with a build in relais to protect the RX-amp during TX.
The 9-circle combiner is on one pcb and Steve added the well known RX-preamp with a 2N5901 to the combiner.
A walk true video by VE6WZ at his location showing the YCCC 9 circle rx array installation.

A note from Steve: Read the YCCC manual, watch all video's, re-read the manual again and think! You needs some knowledge of electronics to build this units. He is not a helpdesk on How-to....

A new 9-circle combiner is designed by Steve without the need of the common mode choke. Also the extra pre-amp has removed in thes design.

photo

A schematic view of the amp for understanding and fault search.

The pcb layout rx-amp.

The value of each component is written in the BOM

Steve describe the rx-amp in a you-tube video

In case of trouble there are 2 video's how to check the pre-amp
YCCC 9 Circle Pre-amp repair
HI-Z vertical field voltage measurement

photo

A schematic view of the combiner for under standing and fault search.

The pcb layout of the combiner.

The value of each component is written in the BOM

Steve describe the 9 circle combiner in a you-tube video.

A test procedure is shown in a video as well

photo

This is the new creation by Steve on the switch unit. There is no need any more for an extrenal common mode choke with the 2 ferrit core and RG179 coax. This uint has build-in common mode choke.

In this video Steve explain this design.

The value of each component is written in the BOM

A schematic view of the combiner for under standing and fault search.

photo

This is a new creation by Steve on the rx-amp at the base of the antennas.

In this video Steve explain this design.

The value of each component is written in the BOM

© Copyright 1996 - 2026 PI4CC All rights reserved.